1. Selection of spherical bearings: Based on working conditions, load conditions, and usage environment, choose appropriate bearing models and specifications, and consider parameters such as material and accuracy to ensure compliance with requirements.
2. Cleaning work: Before installation, ensure that the installation environment is clean and tidy, remove debris and dirt, and clean the bearing surface to ensure smoothness and cleanliness
3. Check accessories: Check the integrity of the accessories, including sealing rings, locking nuts, etc., to ensure that there is no damage or deformation. If there are any problems, replace them in a timely manner.
4. Prepare lubricant: Prepare an appropriate amount of lubricant to minimize friction and wear, and improve bearing life.
5. Prepare installation tools: Prepare special tools such as bearing installation sleeves, hydraulic tensioners, etc. to ensure smooth installation work.
6. Determine installation position and direction: Determine the optimal installation position and direction based on working conditions and bearing type to ensure the normal operation of the bearings.
7. Adjust the clearance and tighten the nut: adjust the appropriate clearance after installation, use manual or hydraulic puller to adjust, and pay attention to the tightening force of the nut.
8. Check the installation quality: After completing the installation, carefully check the quality to ensure that the gap is appropriate, the nuts are tightened in place, and the accessories are complete. Handle problems in a timely manner.
9. Conduct a trial run: After completing the above steps, conduct a trial run to ensure that the bearings are installed correctly, running stably, and there are no abnormal situations.
The execution of these steps can ensure the correct installation of spherical bearings, extend their service life, and ensure the normal operation of the equipment.